Chopper-Stabilized, Precision Hall-Effect Switch
A3340
7
Allegro MicroSystems, Inc.
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
Dwg. EH-012
REG
X
+V
CC
B
V
HALL
+V
HALL
+B
0
FLUX DENSITY
0
B
CC
V
B
+V
OP
RP
V
OUT(SAT)
SUPPLY
OUTPUT
Dwg. EH-013
0.1 糉
SUPPLY
VCC
GND
VOUT
Chopper-Stabilized Technique. The Hall element can be con-
sidered as a resistor array similar to a Wheatstone bridge. A large
portion of the offset is a result of the mismatching of these resis-
tors. These devices use a proprietary dynamic offset cancellation
technique, with an internal high-frequency clock to reduce the
residual offset voltage of the Hall element that is normally caused
by device overmolding, temperature dependencies, and thermal
stress. The chopper-stabilizing technique cancels the mismatch-
ing of the resistor circuit by changing the direction of the current
flowing through the Hall plate using CMOS switches and Hall
voltage measurement taps, while maintaining the Hall-voltage
signal that is induced by the external magnetic flux. The signal
is then captured by a sample-and hold circuit and further pro-
cessed using low-offset bipolar circuitry. This technique produces
devices that have an extremely stable quiescent Hall output volt-
age, are immune to thermal stress, and have precise recoverability
after temperature cycling. This technique will also slightly
degrade the device output repeatability. A relatively high sampling
frequency is used in order that faster signals can be processed.
More detailed descriptions of the circuit operation can be found
in: Technical Paper STP 97-10, Monolithic Magnetic Hall Sensing
Using Dynamic Quadrature Offset Cancellation and Technical
Paper STP 99-1, Chopper-Stabilized Amplifiers With A Track-and-
Hold Signal Demodulator. Operation. The output of these devices
switches high (turns off) when a magnetic field (south pole) per-
pendicular to the Hall element exceeds the operate point thresh-
old (B
OP
). When the magnetic field is reduced below the release
point (B
RP
), the device output goes low (turns on). After turn-on,
the output is capable of sinking 25 mA and the output voltage is
V
OUT(SAT)
. The difference in the magnetic operate and release
points is the hysteresis (B
hys
) of the device. This built-in hyster-
esis allows clean switching of the output even in the presence of
external mechanical vibration and electrical noise. Applications.
It is strongly recommended that an external bypass capacitor be
connected (in close proximity to the Hall element) between the
supply and ground of the device to reduce both external noise and
noise generated by the chopper stabilization technique.
The simplest form of magnet that will operate these devices is a
ring magnet. Other methods of operation, such as linear magnets,
are possible. Extensive applications information on magnets and
Hall-effect devices is also available in Application Note 27701, or
at www.allegromicro.com.
FUNCTIONAL DESCRIPTION
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
A3422LKA-T
IC SENSOR DIRECT/DETECT 5-SIP
AAH002-02
SENSORS MAGNETIC FIELD 8SOIC
AD221-00
SENS MAG SW 20G CROS AXIS 8-MSOP
ADH025-00
SENSOR MAG SW 10G CRS AXS 8-MSOP
ADL024-14E
DIGITAL SWITCH 55HZ ULLGA
AFL300-00
SWITCH MAGNETIC DIG 5.5V 8MSOP
AH173-WL-7-A
IC HALL SENSOR LATCH 25MA SC59-3
AH175-PL-B-B
IC HALL SENSOR BIPO LATCH SIP-3L
相关代理商/技术参数
A3340LLHLT-T
功能描述:IC HALL EFFECT SWITCH SOT-23 RoHS:是 类别:传感器，转换器 >> 磁性 - 霍尔效应，数字式开关，线性，罗盘 (IC) 系列:- 标准包装:1 系列:- 传感范围:20mT ~ 80mT 类型:旋转 电源电压:4.5 V ~ 5.5 V 电流 - 电源:15mA 电流 - 输出（最大）:- 输出类型:数字式，PWM，8.5 位串行 特点:可编程 工作温度:-40°C ~ 150°C 封装/外壳:20-SSOP（0.209"，5.30mm 宽） 供应商设备封装:20-SSOP 包装:Digi-Reel® 其它名称:AS5132-HSST-500DKR
A3340LUA-T
功能描述:IC HALL EFFECT SWITCH 3-SIP RoHS:是 类别:传感器，转换器 >> 磁性 - 霍尔效应，数字式开关，线性，罗盘 (IC) 系列:- 标准包装:1 系列:- 传感范围:20mT ~ 80mT 类型:旋转 电源电压:4.5 V ~ 5.5 V 电流 - 电源:15mA 电流 - 输出（最大）:- 输出类型:数字式，PWM，8.5 位串行 特点:可编程 工作温度:-40°C ~ 150°C 封装/外壳:20-SSOP（0.209"，5.30mm 宽） 供应商设备封装:20-SSOP 包装:Digi-Reel® 其它名称:AS5132-HSST-500DKR
A3342B
制造商: 功能描述: 制造商:New Japan Radio Co Ltd (NJR/JRC) 功能描述: 制造商:undefined 功能描述:
A33463-000
功能描述:可复位保险丝 RoHS:否 制造商:TE Connectivity / Raychem 电流额定值: 电阻:0.08 Ohms (max) 最大直流电压: 保持电流:2.5 A 安装风格:Through Hole 端接类型: 跳闸电流:5 A 引线间隔: 系列:RXEF 工作温度范围:+ 85 C
A33466-000
制造商:TE Connectivity 功能描述:VARISTOR 200V 7MM STRAIGHT LEAD 制造商:TE Connectivity 功能描述:VARISTOR 200V 1.75KA DISC 7MM
A33485-000
制造商:TE Connectivity 功能描述:VARISTOR 680V 6KA DISC 14MM 制造商:TE Connectivity 功能描述:VARISTOR 680VDC 14MM 10% LEADED
A334ERW
制造商:MPD 制造商全称:MicroPower Direct, LLC 功能描述:Low Cost, Wide Input, 3W Single & Dual Output DC/DC Converters
A334FC101M500HU19J
制造商:KEMET Corporation 功能描述:100UFV - Boxed Product (Development Kits)